About

We first started laser crystal and internal engraving software in 2002.we got a lot of sales in 2003. At the beginning of 2004, we discovered that a company pirated our software .So we applied for software copyright.

Later, the research and development of 3D printing software and picosecond cutting software were carried out.

The motion controller is in response to the needs of software control. During the development of the software, many unsatisfactory in control cards were found, so the motion controller was developed. At the beginning, ARM CM3 LPC1768 was used as the main controller. Later, it was necessary to adapt the digital galvanometer to realize the xy2-100 protocol. It was changed to FPGA, which was originally from ALTER Company, and later changed to Xilinx’s Zynq 7000 as the main controller.